A lot of belt porisity is lost from build up on the backs of the belts.
Viewed: 362 times.
|
Water alone is not always enough to keep the polymer and grease build-up off of the filter media.
Viewed: 324 times.
|
A one hour evalation by a qualified Schaner's representative can assist you in diagnosing your machine.
Viewed: 288 times.
|
The smallest of build-ups will cost your hours of production and your sludge quality.
Viewed: 298 times.
|
A polygone demonstration is simply this pump hooked up to your wash water line.
Viewed: 300 times.
|
Ordinarily, your filter cloths can look this much better in a short period of time with Polygone!
Viewed: 316 times.
|
The following series of photos are representative of the shortcomings of operations in the USA!
Viewed: 291 times.
|
Striping of sludge and polymer is obvious.
Viewed: 298 times.
|
The spray systems are not enough for this operation!
Viewed: 261 times.
|
Too much polymer is being used to get the job done!
Viewed: 325 times.
|
Sludge release is limited at best!
Viewed: 309 times.
|
Can you see the lost productivity here? We can!
Viewed: 300 times.
|
The sludge build up must be removed for success!
Viewed: 296 times.
|
Unfortunately, many plants have learned to accept this as normal!
Viewed: 316 times.
|
Too much polymer left on the belts can be just as damaging to an operation.
Viewed: 278 times.
|
This sludge is difficult to dewater.
Viewed: 299 times.
|
The sludge slides back to the headbox on this incline
Viewed: 296 times.
|
The doctor blade is not enough to keep the sludge from going back to the rinse box!
Viewed: 276 times.
|
This machine has lost over half of its usable space to dewater!
Viewed: 310 times.
|
Schaner's can eliminate a lot of this grief!
Viewed: 285 times.
|
